Analysis of Three Mistakes in Badge Customization

First, the choice of style. Many people see the renderings on paper and always want to add many things and elements, but after making them, they find that there are too many contents. On the contrary, it is not prominent enough to wear it. You need to get close to it to see it. However, if you wear it frequently, it is better not to wear too much content. It is enough to highlight the corporate logo. Therefore, how to make a choice in customizing the badge determines whether your finished product matches your needs.

Second, the selection of the back buckle. At present, the installation process of the back buckle is also divided into several types. The badges made by some enterprises are more meaningful for collection, so the pursuit is more beautiful than practical. Some enterprises require employees to wear them every day, so it is necessary to pay attention to the firmness of the back buckle. I can't take it with me. It just dropped a few days ago. It is quite troublesome to repair. One is to use high-strength industrial glue to stick it on. This method is manual operation, so the process of sticking is good and bad. But there is no need to say about the beauty. Another process is soldering. The back pin and the back of the badge are soldered together, so that even if you pull it hard, it will not fall off. But there is also a small defect. Maybe there will be a little paint on the back during soldering. A little paint will not be seen on the back. So you should choose according to the requirements of your enterprise. The soldering process is usually more expensive because the needle is relatively small.

Third, the difference between molds. There are two common mold opening processes that Xiaobian often contacts. One is casting, then pressing and trimming. How to describe it, for example, making popsicles at home. First, I open a mold, then I pour water in, and then I take out the formed popsicles. This is a kind of process. The advantage of this process is that it is fast, but the disadvantage is that it is not careful enough. Especially some relatively small lines are difficult to make. And because of this process, some processes cannot be added. If we do some works with high requirements, the finished products made by mold opening will not work. Another way of mold opening is to melt the materials and press them into gold, silver and copper cakes with a hydraulic press. For example, our finished products need to be 2mm thick. Then we first press them into 2mm embryo cakes, and then combine carving, mirror, and embossing processes to make a delicate mold. The pattern produced by this method, as well as the problem of process superposition, can be solved. This method alone will also be time-consuming. This is the combination of traditional badge technology and modern coinage technology. So some molds can be hundreds of pieces, while some molds are thousands of pieces. When you know whether you want the finished product with high quality requirements, then choose the mold to produce, Don't spend money but don't get good technological results.

The editor here introduces the classification process of badges to help you distinguish various badges, and from that, you can get out of the misunderstanding of badges customization and choose the most suitable badges for yourself, with low cost and high cost performance.